Showing posts with label tachometer. Show all posts
Showing posts with label tachometer. Show all posts

Tuesday, May 14, 2013

Wiring Marine Tachometer Diesel Alternator Instructions

Alternator Wiring Diagram on In The Diagram Above The Red Wire From The Old
In The Diagram Above The Red Wire From The Old.


Alternator Wiring Diagram on Wiring Diagram For Gm Alternators
Wiring Diagram For Gm Alternators.


Alternator Wiring Diagram on Internal Regulator Alternator Testing Guide
Internal Regulator Alternator Testing Guide.


Alternator Wiring Diagram on Wiring 12v Marine Tachometer Diesel Alternator Instructions   How To
Wiring 12v Marine Tachometer Diesel Alternator Instructions How To.


Alternator Wiring Diagram on Delco One Wire Alternator Installation On 5000 Ford Mf135 Wiring Rjs
Delco One Wire Alternator Installation On 5000 Ford Mf135 Wiring Rjs.


Alternator Wiring Diagram on Here S A Wiring Diagram For The Denso Alternator
Here S A Wiring Diagram For The Denso Alternator.


Alternator Wiring Diagram on Typical Alternator Wiring Diagram An Alternator Is A Three
Typical Alternator Wiring Diagram An Alternator Is A Three.


Alternator Wiring Diagram on Westfield World Kitcar Support Site   Wiring A Nippon Denso Alternator
Westfield World Kitcar Support Site Wiring A Nippon Denso Alternator.


Alternator Wiring Diagram on Suggested Wiring Diagram For Alternator Field Disconnect Circuit
Suggested Wiring Diagram For Alternator Field Disconnect Circuit.


Alternator Wiring Diagram on Thread  Auto  Leco S   Help With Some Alternator Wiring Please
Thread Auto Leco S Help With Some Alternator Wiring Please.
Read More..

Sunday, April 7, 2013

Tachometer Circuit Using LM2907 LM2917 Frequency to Voltage Converter

This is a design circuit for tachometer circuit based on the LM2907 IC can be used to provide zero crossing datum to a digital system. At each zero crossing of the input signal the charge pump changes the state of capacitor C1 and provides a one-shot pulse into the zener diode at pin 3. The width of this pulse is controlled by the internal current of pin 2 and the size of capacitor C1 as well as by the supply voltage. This is the figure of the circuit;


Since a pulse is generated by each zero crossing of the input signal we call this a ``two-shot instead of a ``one-shot device and this can be used for doubling the frequency that is presented to the microprocessor control system. This electronic tachometer circuit project can be powered from a 12, 15 volt DC power supply circuit. Input can be from plus /minus 20 mV to plus/minus 28V. Pulse width is equal with (VCC/2)x(C1/I2) and the Pulse height is equal with VZENER.
Read More..