Wiring Circuit

This is the video amplifier schema with splitter, it is designed to amplify the video signal, compensating for the loss of signal because this signal will then be split up to three outputs. The output signals may be used in television monitors, recording at the same time several DVDs, etc. .. The advantage of this schema is that it is quite cheap, easy to build and the results are very good.

Splitter and Amplifier Video Circuit Diagram

The video amplifier schema has a maximum gain ratio of only 4 times the impedance is 75 ohms on the input and output, and wide bandwidth of this schema is 5 Mhz

adjust VR1
1. Adjusting VR1 until the voltage at the base of Q1 is equal to one volt. And is the voltage drop across R7. (No input signal). Approximately 0.75 volts.
2. Adjust VR1 in the middle Enter the input signal is 1 Vp-p, then adjust VR2 to have the lowest rate of increase.
Then turn on the TV or monitor to the output and then adjust VR1 until the test signal to be applied without distortion.

PCB