Showing posts with label project. Show all posts
Showing posts with label project. Show all posts
Thursday, November 13, 2014
NJM2582 bassed 4 channel video amplifier electronic project circuit with explanation
A very simple 4 channel video amplifier electronic circuit project can be designed using NJM2582 ic suitable for video applications with SCART connector . Design of the circuit is very simple and require few external electronic parts .
Some features of the NJM2582 are : Operating Voltage ±5V, +5V, +11V ; 6input 4output , 2input 1output Video SW , Internal LPF , 6dB Amplifier , Internal 75Ω Driver Circuit , DC output for SCART (FUNCTION SW, BLANKING) .
Thursday, November 6, 2014
Solar Charger Circuit Project Using Transistors
This is a simple solar charger circuit project can be designed using few external electronic parts . This simple solar charger circuit is capable of handling charge currents of up to 1A. Alternate component values are given in the figure for lower current applications.
Solar Charger Circuit Project Using Transistors circuit diagram :
The only adjustment is the voltage trip point when the current is shunted through the transistor and load resistor. This should be set with a fully charged battery. As the transistor and R3 have the entire panel’s output across them when the battery is fully charged, all of the current from the panel will be going through R3 and the Darlington transistor TIP112, so these must be well heat sunk. Adjust R1 for the trip point, usually 14.4 V – 15 V for a 12 V SLA or a 12 V Ni-Cd battery.
Friday, October 10, 2014
NCP2824 Class D amplifier electronic project circuit and explanation
Using the NCP2824 filterless Class D amplifier can be designed a very simple low power audio amplifier electronic project, capable of delivering up to 2.4 W to a 4 ohms load with a 5 V supply voltage.
With the same battery voltage, it can deliver 1.2 W to an 8 ohms load with less than 1% THD+N. The non−clipping function automatically adjusts the output voltage in order to control the distortion when an excessive input is applied to the amplifier.
This adjustment is done thanks to an Automatic Gain Control circuitry (AGC) built into the chip. A simple single wire interface allows to the non Clipping function to be enabled and disabled.
A programmable power limit function is also embedded in order to protect speakers from damage caused by an excessive sound level.
Subscribe to:
Posts (Atom)